Introduction

Once we have opened the Kurio 7, we may need to remove the motherboard in order to reach other components so that the Kurio 7 will work.

Begin by removing the rubber cover from the Kurio 7.
  • Begin by removing the rubber cover from the Kurio 7.

Ajouter un commentaire

Remove the  four 30 mm Phillips #00 screws from the outer case.
  • Remove the four 30 mm Phillips #00 screws from the outer case.

Ajouter un commentaire

  • Insert the plastic opening tool in the gap between the front cover and the back cover of the device.

  • Slide the plastic opening tool around the edge of the device. Gently pry apart the tabs that hold the front cover and the back cover together.

  • Be careful not to break off the tabs that hold the front cover and the back cover together.

Ajouter un commentaire

  • Once all of the tabs are removed, the back cover should come off easily.

  • Gently remove the back cover. There are wires inside that may get caught on the cover while removing it. These wires are soldered to their components and are difficult to reattach.

Ajouter un commentaire

  • Use a plastic credit card, or other thin object, to separate the battery from the screen.

  • Be sure to work the card carefully and slowly around in order to not damage, break, or deform the battery.

  • Carefully set the battery aside.

Ajouter un commentaire

  • Use a Phillips #00 screwdriver to remove the eight 40mm screws holding the motherboard in place.

Ajouter un commentaire

  • Place the plastic opening tool on the base of the black ribbon clip and pull up, like a lever, to release the mount. This should release the clip holding the ribbon to the mount.

  • Pull the ribbon out of the mount.

Ajouter un commentaire

  • There should be masking tape on the yellow ribbon. Pull the tape off of the motherboard and wrap it around the yellow ribbon.

  • Do not pull the tape completely off the motherboard, as it is used to protect components on the ribbon.

  • To remove the ribbon from the mount, follow the same steps in Step 3.

Ajouter un commentaire

  • Pull back the ribbons and put the battery near the bottom of the Kurio.

  • The motherboard is now removed so that other components can be worked on.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Eric Rice

Membre depuis le 14/04/2014

838 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 12-36, Maness Spring 2014 Membre de l'équipe Cal Poly, Team 12-36, Maness Spring 2014

CPSU-MANESS-S14S12G36

4 membres

7 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 1

30 derniers jours : 13

Total : 2,754