Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Introduction

A step-by-step rear camera replacement guide for the Kyocera Hydro Life smartphone.

  1. Flip the phone so that the screen is facing down.
    • Flip the phone so that the screen is facing down.

    • Gently remove the back cover with the grip at the bottom of the phone.

  2. Use the tab marked "PULL" to remove the battery from its enclosure. Use the tab marked "PULL" to remove the battery from its enclosure. Use the tab marked "PULL" to remove the battery from its enclosure.
    • Use the tab marked "PULL" to remove the battery from its enclosure.

  3. Using the PH00 bit for the screwdriver, remove the 6 screws on the back of the enclosure. Use a plastic opening tool to gently remove the plastic piece surrounding the back of the phone enclosure. Use a plastic opening tool to gently remove the plastic piece surrounding the back of the phone enclosure.
    • Using the PH00 bit for the screwdriver, remove the 6 screws on the back of the enclosure.

    • Use a plastic opening tool to gently remove the plastic piece surrounding the back of the phone enclosure.

  4. Remove the white sticker.
    • Remove the white sticker.

  5. Using a pair of pliers, gently pry open the camera ribbon slot. This will not take much pressure to open.
    • Using a pair of pliers, gently pry open the camera ribbon slot.

    • This will not take much pressure to open.

  6. Gently remove  the camera ribbon.
    • Gently remove the camera ribbon.

    • Be very careful not to rip the ribbon. Use tweezers if needed.

  7. Using a plastic prying tool, gently loosen all 4 corners of the motherboard. Lift the motherboard away from the phone enclosure.
    • Using a plastic prying tool, gently loosen all 4 corners of the motherboard.

    • Lift the motherboard away from the phone enclosure.

  8. Remove the black sticker.
    • Remove the black sticker.

    • Be careful when removing the sticker. The sticker will need to be replaced after replacing the camera.

  9. Remove the camera from the motherboard.
    • Remove the camera from the motherboard.

    • This step requires breaking metal.

    • Only cut along the camera square.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Morgan Marshall

Membre depuis le 21/09/2018

277 Réputation

2 tutoriels rédigés

Équipe

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 1

7 derniers jours : 5

30 derniers jours : 17

Total : 98