Aller au contenu principal

Introduction

If you have damaged your side case, it is possible to replace. It requires time, a lot of disassembling, and includes many small parts.

  1. Apply an upward force to slide the back cover off.
    • Apply an upward force to slide the back cover off.

  2. Use your finger to push down on the top of the battery and pull it out.
    • Use your finger to push down on the top of the battery and pull it out.

  3. Remove the five 3.0mm Phillips #000 screws along the edge of the rear case.
    • Remove the five 3.0mm Phillips #000 screws along the edge of the rear case.

  4. Use a plastic opening tool to pry the rear case loose.
    • Use a plastic opening tool to pry the rear case loose.

  5. Once the rear case is loose, lift it from the rest of the phone.
    • Once the rear case is loose, lift it from the rest of the phone.

  6. Fix Kits pour Android

    A new screen or battery is one kit away.

    Acheter maintenant

    Fix Kits pour Android

    A new screen or battery is one kit away.

    Acheter maintenant
  7. Remove the two 2.9 mm Phillips #000 screws that are slightly off-centered to the right.
    • Remove the two 2.9 mm Phillips #000 screws that are slightly off-centered to the right.

  8. Use the plastic opening tool to pry the motherboard loose.
    • Use the plastic opening tool to pry the motherboard loose.

  9. Hold the motherboard from the top and bottom and slowly lift the motherboard until you feel a pull.
    • Hold the motherboard from the top and bottom and slowly lift the motherboard until you feel a pull.

    • The flex cable is attached at the bottom of the motherboard and can be damaged if too much lifting force is applied.

  10. Once the motherboard is lifted , rotate the motherboard up 90 degrees to the right.
    • Once the motherboard is lifted , rotate the motherboard up 90 degrees to the right.

  11. Use your finger to pull the flex cable out from its connector.
    • Use your finger to pull the flex cable out from its connector.

  12. Pull the motherboard away from the rest of the phone.
    • Pull the motherboard away from the rest of the phone.

  13. Lift the silicon keypad away from the rest of the phone.
    • Lift the silicon keypad away from the rest of the phone.

  14. Remove the four 2.0mm Phillips #000 screws on the golden squares.
    • Remove the four 2.0mm Phillips #000 screws on the golden squares.

  15. Slowly lift the side case away from the rest of the phone.
    • Slowly lift the side case away from the rest of the phone.

    • The flex cable can be torn if it is caught on the frame of the side case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Johnny Phane

Membre depuis le 15/04/2013

28 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 13-63, Johann Spring 2013 Membre de l'équipe Cal Poly, Team 13-63, Johann Spring 2013

CPSU-JOHANN-S13S13G63

3 membres

10 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 2

Total : 941