Introduction
In addition to protecting the internal components of the watch, the back case also fastens the power charging conductor and heart rate monitor to the watch's motherboard.
Ce dont vous avez besoin
-
-
Place the watch upside down on a hard surface so that its back case is facing upright.
-
Use a T4 Torx Star screwdriver to remove the four 4.0 mm Torx screws from the corners of the back case.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.