Aller au contenu principal

Introduction

If the buckle or part of the wristband is damaged, it is a good idea to replace the bands on both sides so that they match.

Outils

Pièces

Aucune pièce spécifiée.

  1. Spring bars attach the two halves of the wristband to the watch body. The spring bar has a shoulder on either end.
    • Spring bars attach the two halves of the wristband to the watch body. The spring bar has a shoulder on either end.

    • Be prepared to apply some pressure with your fingers to perform the following action.

    • First, slide the wristband down on the spring bar to expose the shoulder of the spring bar.

    • Grasp the exposed shoulder with the tweezers to perform the next step.

  2. This is a challenging step. Do it carefully to prevent the spring bar from flying out of the wristband. Use the tweezer to depress the spring bar so that it collapses by a few millimeters and pops out of the hole that was holding it in place.
    • This is a challenging step. Do it carefully to prevent the spring bar from flying out of the wristband.

    • Use the tweezer to depress the spring bar so that it collapses by a few millimeters and pops out of the hole that was holding it in place.

    • Now carefully pull the other end of the spring bar to detach the wristband from the watch face.

    • Repeat steps 1 and 2 for the other wristband.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Deja Miller

Membre depuis le 14/10/2014

462 Réputation

3 tutoriels rédigés

Équipe

USF Tampa, Team 2-5, Blackwell Fall 2014 Membre de l'équipe USF Tampa, Team 2-5, Blackwell Fall 2014

USFT-BLACKWELL-F14S2G5

5 membres

5 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 2

Total : 716