Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Remplissez une casserole ou une poêle avec suffisamment d'eau pour immerger complètement un iOpener.
-
Faites chauffer l'eau jusqu'à ébullition. Puis éteignez le feu.
-
Placez un iOpener dans l'eau chaude pendant 2 à 3 minutes. Assurez-vous que l'iOpener est complètement immergé dans l'eau.
-
Utilisez des pinces pour extraire l'iOpener chauffé de l'eau chaude.
-
Séchez soigneusement l'iOpener avec une serviette.
-
Votre iOpener est prêt à être utilisé ! Si vous devez réchauffer l'iOpener, portez l'eau à ébullition, éteignez le feu et placez l'iOpener dans l'eau pendant 2 à 3 minutes.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Apply the heated iOpener to the edge of the phone for about 2 minutes.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
Outil utilisé dans cette étape :Plastic Cards$2.99-
When the back panel is heated, apply the suction cup close to a corner of the phone. Lift up and insert a halberd spudger or opening pick under the rear glass.
-
Slide the blade of the Halberd spudger along the edge of the phone to separate the adhesive.
-
Follow around the edge of the phone, and use an opening pick or other tool (such as a plastic card) to keep already opened portions from re-adhering.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Using a Philips 000 bit, remove 11 screws from the highlighted locations.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
With the screws removed, remove the lower frame components, followed by the upper mid-frame. Both components can be removed with a little prying.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Begin battery removal by very gently prying off the power ribbon with a plastic card or a nylon spudger.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Firmly pull the blue tab. Be careful not to bend the battery as you pull it away from the adhesive.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Locate the sim card tray release mechanism on the right edge.
-
Using the tweezers, or similar thin and rigid tool, push in the release button and pull out the sim card tray.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Gently pry off the two connectors at the bottom of the phone.
-
Pry off the tape covering the vibrator.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
The motherboard is now removable by gently lifting.
-
Annulation : je n'ai pas terminé ce tutoriel.
4 autres ont terminé cette réparation.
4 commentaires
Hi where i can find mainborad for lg g6 h870
i found one on ebay
Greg -
How much access to the SIM Reader does this give you? A customer has broken his SIM Tray and there is a part stuck inside, will removing the board allow me to reach this or would I be removing it for no reason?
Any response appreciated, ty.