Introduction

After completing the inner cover, you can access the rear-facing camera.

Pièces

Aucune pièce nécessaire.

Make sure before you begin working on your device, that the device is not charging.
  • Make sure before you begin working on your device, that the device is not charging.

  • Once you have access to the phone, there is a small indent on the bottom left side. Use your fingernail or a plastic opening tool to pry from here and pull off the back casing.

Ajouter un commentaire

Once you have properly removed the outer casing, the back should look as so.
  • Once you have properly removed the outer casing, the back should look as so.

  • To remove the battery, pull up from the red mark using your finger. The battery should come up at an angle, and easily be able to be removed.

  • Once the battery is removed you may safely proceed to the next step.

Ajouter un commentaire

  • Make sure you remove the battery first. You will see that there are 14 screws on the back of the inner case. Use the Phillips head screwdriver to remove each of the screws, make sure to put the screws in a safe place where they will not get lost.

Ajouter un commentaire

  • Once you have removed all the screws, you can begin removing the inside cover.

  • Insert the opening tool using a sliding motion into one of the corners and move it along the edges of the inside cover. This will loosen the edges and the inside cover will pry apart from the shell.

Ajouter un commentaire

  • The inner cover is now removed, you now have access to the many parts on the inside of the phone.

Ajouter un commentaire

  • Using a plastic opening tool, pry the connection between the cable and the phone. With even pressure the cable should disconnect from the logic board easily.

Ajouter un commentaire

  • After removing the the Ribbon Cable, the Rear-Facing Camera should be able to be removed easily with your fingers.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Wesley Pate

Membre depuis le 25/09/2014

1 620 Réputation

7 tutoriels rédigés

Équipe

USF Tampa, Team 15-5, Remmell Fall 2014 Membre de l'équipe USF Tampa, Team 15-5, Remmell Fall 2014

USFT-REMMELL-F14S15G5

3 membres

7 tutoriels rédigés

Question what is the thing with a weird looking number 6 , right above the battery... I broke that and trying to replace it. Also can i replace the LCD only

DENNIS - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 12

Total : 1,708