Introduction

This is a guide to replace a broken or damaged rear camera on the LG Rebel. This could be important if the camera became foggy or cracked. Be careful, as these are small parts and could be sharp if broken.

Turn the phone on its side and locate the small groove. Use the plastic opening tool to take the back cover off of the phone.
  • Turn the phone on its side and locate the small groove.

  • Use the plastic opening tool to take the back cover off of the phone.

Ajouter un commentaire

Locate the small groove on the back of the phone near the bottom. Use the metal spudger to pop open the black plastic covering. Remove black plastic covering.
  • Locate the small groove on the back of the phone near the bottom.

  • Use the metal spudger to pop open the black plastic covering.

  • Remove black plastic covering.

Ajouter un commentaire

Use the metal spudger to pop up the black plastic covering near top of phone. Remove the black plastic covering.
  • Use the metal spudger to pop up the black plastic covering near top of phone.

  • Remove the black plastic covering.

Ajouter un commentaire

Locate the connective pieces on the back of the phone. Use the metal spudger to disconnect both of the connective pieces from the back. Use the metal spudger to disconnect both of the connective pieces from the back.
  • Locate the connective pieces on the back of the phone.

  • Use the metal spudger to disconnect both of the connective pieces from the back.

Ajouter un commentaire

Flip the phone over so the screen is facing up. Slide the metal spudger around the perimeter of the phone until the entire seal has been broken. Use the small suction cup to remove the screen.
  • Flip the phone over so the screen is facing up.

  • Slide the metal spudger around the perimeter of the phone until the entire seal has been broken.

  • Use the small suction cup to remove the screen.

Ajouter un commentaire

Locate the black bumper at the bottom of the front of the phone. Use the metal spudger to slide the bumper out.
  • Locate the black bumper at the bottom of the front of the phone.

  • Use the metal spudger to slide the bumper out.

Ajouter un commentaire

Use the metal spudger to carefully loosen the motherboard from the body of the phone. Slowly slide the motherboard out of the body of the phone. Remove the motherboard.
  • Use the metal spudger to carefully loosen the motherboard from the body of the phone.

  • Slowly slide the motherboard out of the body of the phone.

  • Remove the motherboard.

Ajouter un commentaire

Locate the rear camera on the motherboard. Use the metal spudger to disconnect the connective piece at the base of the camera.
  • Locate the rear camera on the motherboard.

  • Use the metal spudger to disconnect the connective piece at the base of the camera.

  • Remove the camera.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Emma Johnson

Membre depuis le 08/02/2018

184 Réputation

1 tutoriel rédigé

Équipe

Sam Houston State, Team S16-G2, Nardone Spring 2018 Membre de l'équipe Sam Houston State, Team S16-G2, Nardone Spring 2018

SHSU-NARDONE-S18S16G2

5 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 4

Total : 58