Introduction

This guide will teach you how to properly replace the LCD screen and touch digitizer with frame. Precaution should be taken if handling a cracked screen to avoid cuts from broken glass. This repair may be needed if the screen is unresponsive to touch or the screen has been damaged or cracked.

Insert a fingernail, or plastic opening tool, into the cutout on the back cover and pry outward to remove.
  • Insert a fingernail, or plastic opening tool, into the cutout on the back cover and pry outward to remove.

Ajouter un commentaire

Pull the battery out of the phone.
  • Pull the battery out of the phone.

  • Remove the SD Card by sliding the card out as shown.

Ajouter un commentaire

  • Remove the twelve 2mm JIS #00 screws from the mid-frame.

Ajouter un commentaire

  • Using a plastic opening tool, remove the antenna extender from the bottom.

Ajouter un commentaire

  • Using your fingers, remove the mid-frame.

Ajouter un commentaire

  • Use a plastic opening tool to disconnect the front and rear cameras from the motherboard.

  • Remove the cameras from the phone.

Ajouter un commentaire

  • Using a plastic opening tool, pry up the front facing speaker and remove it from the phone.

Ajouter un commentaire

  • Disconnect the LCD from the motherboard with a plastic opening tool.

Ajouter un commentaire

  • Use a plastic opening tool to pry up the motherboard form the display housing.

  • Remove the motherboard from the phone.

Ajouter un commentaire

  • Use your fingers to remove the flex cables from the phone.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Aalia Mohammed

Membre depuis le 14/02/2018

428 Réputation

4 tutoriels rédigés

Équipe

USF Tampa, Team S1-G3, Nance Spring 2018 Membre de l'équipe USF Tampa, Team S1-G3, Nance Spring 2018

USFT-NANCE-S18S1G3

4 membres

10 tutoriels rédigés

Just a note that the flex cables are stuck pretty well to the case. I didn’t rip them but I used a little heat from a hair dryer to soften the glue a bit.

christophergosnell - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 10

30 derniers jours : 75

Total : 217