Aller au contenu principal

Pièces

Aucune pièce spécifiée.

  1. Turn the phone off. Remove the back cover by sliding the tab away from the phone using one finger.
    • Turn the phone off.

    • Remove the back cover by sliding the tab away from the phone using one finger.

  2. Lift one side of the battery using a plastic opening tool or your fingers.
    • Lift one side of the battery using a plastic opening tool or your fingers.

    • Carefully remove the battery and set it aside.

  3. When installing the battery, make sure to align the metal pins with those of the phone.
    • When installing the battery, make sure to align the metal pins with those of the phone.

  4. Use a Phillips #0 Screwdriver to remove the nine 4 mm screws from the back cover. Use a Phillips #0 Screwdriver to remove the nine 4 mm screws from the back cover.
    • Use a Phillips #0 Screwdriver to remove the nine 4 mm screws from the back cover.

  5. Insert the tip of the plastic opening tool into the small notch on the side of the case. Slide the opening tool along the seam and around the edge of the phone to separate the case.
    • Insert the tip of the plastic opening tool into the small notch on the side of the case.

    • Slide the opening tool along the seam and around the edge of the phone to separate the case.

  6. Separate the two halves of the phone.
    • Separate the two halves of the phone.

    • On the left is the back of the phone holding the logic board and key pad.

    • On the right is the plastic casing.

  7. Holding  the phone casing with one hand, and the key pad assembly with the other, separate the phone case from the keypad/logic board. Holding  the phone casing with one hand, and the key pad assembly with the other, separate the phone case from the keypad/logic board. Holding  the phone casing with one hand, and the key pad assembly with the other, separate the phone case from the keypad/logic board.
    • Holding the phone casing with one hand, and the key pad assembly with the other, separate the phone case from the keypad/logic board.

  8. Remove the key pad from the logic board by pulling the two boards apart, separating this connection. Remove the key pad from the logic board by pulling the two boards apart, separating this connection.
    • Remove the key pad from the logic board by pulling the two boards apart, separating this connection.

  9. First, pull back the tape covering the connection between the motherboard and the ribbon cable.
    • First, pull back the tape covering the connection between the motherboard and the ribbon cable.

    • Separate the connection, using the plastic opening tool.

  10. After the connection is removed, the motherboard is successfully removed. After the connection is removed, the motherboard is successfully removed.
    • After the connection is removed, the motherboard is successfully removed.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Stanley Thomas

Membre depuis le 20/01/2012

38 Réputation

4 tutoriels rédigés

Équipe

Cal Poly, Team 8-16, Maness Winter 2012 Membre de l'équipe Cal Poly, Team 8-16, Maness Winter 2012

CPSU-MANESS-W12S8G16

4 membres

14 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,189