Introduction

If the laser is not turning on, or flickering, the problem may be caused by a faulty leaf spring. In order to replace this part, follow the steps in this guide.

  1. Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
    • Place the blaster upside down on the table, and remove the screw in the bottom of the handle.

    • Remove the battery door and take the batteries out.

  2. Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside. Lift the side of the blaster off exposing its internal parts. Lift the side of the blaster off exposing its internal parts.
    • Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.

    • Lift the side of the blaster off exposing its internal parts.

  3. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Vous avez déjà réparé quelque chose ? Vous êtes un génie.

    Partagez votre réparation avec le hashtag #ImAGenius

    Nous sommes tous des génies

    Partagez votre réparation avec le hashtag #ImAGenius

  4. Work the trigger to ensure the problem is the switch not making a proper connection.
    • Work the trigger to ensure the problem is the switch not making a proper connection.

    • Remove the retaining phillips head 10.2 mm screw below the switch.

  5. Use a hot soldering iron to melt the solder of the two wires at the rear of the switch.  Take note that the red wire leads from the top of the switch.
    • Use a hot soldering iron to melt the solder of the two wires at the rear of the switch. Take note that the red wire leads from the top of the switch.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Jeffrey Sargeant

Membre depuis le 24/02/2014

318 Réputation

1 tutoriel rédigé

Équipe

Michigan Tech, Team 5-8, Lauer Spring 2014 Membre de l'équipe Michigan Tech, Team 5-8, Lauer Spring 2014

MTU-LAUER-S14S5G8

3 membres

9 tutoriels rédigés

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 2

30 derniers jours : 9

Total : 1,338