Aller au contenu principal

Introduction

The guide will show you how to remove the storage hard drive unit that comes with the laptop. It is compatible with any 2.5" storage solutions like a SSD or HDD.

Pièces

Aucune pièce spécifiée.

  1. Using the Phillips #0 screwdriver, remove the (11) eleven 5.4 mm screws from the back panel. Using the Phillips #0 screwdriver, remove the (11) eleven 5.4 mm screws from the back panel.
    • Using the Phillips #0 screwdriver, remove the (11) eleven 5.4 mm screws from the back panel.

  2. Using a plastic opening tool, pull out the back panel from the laptop. Using a plastic opening tool, pull out the back panel from the laptop.
    • Using a plastic opening tool, pull out the back panel from the laptop.

  3. Using the Phillips #0 screwdriver, remove the (2) 5.4 mm screws. Disconnect the battery connector from the motherboard. Disconnect the battery connector from the motherboard.
    • Using the Phillips #0 screwdriver, remove the (2) 5.4 mm screws.

    • Disconnect the battery connector from the motherboard.

  4. Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant

    Batteries pour ordinateurs portables

    Une réparation facile pour un gain en puissance max.

    Acheter maintenant
  5. Pull the battery outward and remove it from the rest of the laptop.
    • Pull the battery outward and remove it from the rest of the laptop.

  6. Using the Phillips #0 screwdriver, remove the (3) three 3 mm screws. Using the Phillips #0 screwdriver, remove the (3) three 3 mm screws.
    • Using the Phillips #0 screwdriver, remove the (3) three 3 mm screws.

  7. Slide the drive away from the connector by applying pressure on the two side tabs where screws were removed. Use a plastic opening tool as a lever to lift the drive out. Slide the drive away from the connector by applying pressure on the two side tabs where screws were removed. Use a plastic opening tool as a lever to lift the drive out.
    • Slide the drive away from the connector by applying pressure on the two side tabs where screws were removed. Use a plastic opening tool as a lever to lift the drive out.

  8. Carefully, using your hand, remove the hard drive from the laptop. Carefully, using your hand, remove the hard drive from the laptop.
    • Carefully, using your hand, remove the hard drive from the laptop.

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 autre(s) ont terminé cette réparation.

Julian Escallon

Membre depuis le 27/09/2017

609 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team S14-G1, Boczar Fall 2017 Membre de l'équipe USF Tampa, Team S14-G1, Boczar Fall 2017

USFT-BOCZAR-F17S14G1

4 membres

5 tutoriels rédigés

The Edge 2 requires a hard drive of 7mm or less or the bottom cover will not fit properly.

randylovely - Réponse

Thank you, was looking everywhere to find that out!!!

christopher busse -

Thank you, your help was so useful.

Alejandro E Jecke - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 18

30 derniers jours : 81

Total : 1,951