Lenovo IdeaPad U350 RAM Replacement

Rédigé par : James Morizzo (et 2 autres contributeurs)

Commentaires : 0
Favoris : 0

Difficulté

Modérée

Étapes

Temps nécessaire

Proposer une durée de réparation??

Introduction

RAM, or random access memory, is a form of computer data storage. RAM is used to quickly read and write data which the computer needs rapid access to. If a computer is running very slowly, it may not have enough RAM. In this scenario, the computer reads and writes to 'virtual RAM', also known as 'pagefile', on the hard drive. This is much slower.

Outils

Acheter ces outils

Phillips #1 Screwdriver

6,99 $US

Acheter

Pièces

Aucune pièce spécifiée.

Étape 1 RAM

Unscrew the six screws on the back panel of the laptop using a PH1 Phillips bit.

Unscrew the six screws on the back panel of the laptop using a PH1 Phillips bit.
These screws are 4.7mm long with a head diameter of 3.68mm.
The screws are attached to the panel. When unscrewing be sure to stop when you hear a click.

Modifier

Étape 2

Gently lift the back panel from the side closest to the battery and remove panel

Gently lift the back panel from the side closest to the battery and remove panel

Modifier

Étape 3

Push retention clips outward and then gently slide out of slot

Push retention clips outward and then gently slide out of slot

Modifier

Étape 4

Remove white and black wires to make room to remove the second RAM module.

Remove white and black wires to make room to remove the second RAM module.

Modifier

Étape 5

Just like RAM Module 1, push retention clips outward and gently slide out the RAM Module.

Just like RAM Module 1, push retention clips outward and gently slide out the RAM Module.
When re-installing RAM modules, be sure to insert them at a 45 degree angle. This is the same angle that they should pop up to after the retention clips are pushed outward.

Modifier