Introduction

Battery removal is easy. All you have to do is remove the back cover, system board cover and a disconnect a wire! Let's get started!

Pièces

Aucune pièce nécessaire.

Be sure to power off your device before taking it apart.
  • Be sure to power off your device before taking it apart.

  • Locate the small tab, marked with the lock symbol on the upper right hand of your IdeaTab above the volume control buttons. Use your fingernail to gently loosen this tab.

  • Use your Phillips #000 screwdriver and remove the 3.5mm screw and put it aside.

  • Using your blue, plastic opening tool, begin to gently pry the back panel away from the front panel starting by where the screw was.

Removing the screw under the tab on the upper left side is advisable, before trying to pry apart the front and rear covers. Both of these screws may be hidden under security stickers.

Stuart Watson - Réponse

Note the different lengths of these screws: ‘Upper left’ screw is the shorter of the two. Replace them in their original locations.

Stuart Watson - Réponse

Locate the black back plate, above the battery.
  • Locate the black back plate, above the battery.

  • Using a Phillips #000 screwdriver remove the 7 silver 3.5mm screws from the back plate.

  • Next, with the same screwdriver, remove the black 4.1mm screw.

  • Gently remove the back plate from the device.

Ajouter un commentaire

  • Use the plastic opening tool to disconnect the battery wires from the system board. Slide your opening tool under the white plastic piece and pry it up.

  • Again, use the plastic opening tool to loosen the battery from the device by lifting up on the battery on all sides. This will detach the battery from the adhesive.

  • Gently place the battery aside.

What do you do after you take the battery out?

Johnny Stafford - Réponse

What is the type of press-on connector used for the LENOVO L12T1P33? I need to order them.

WmJ Robinson - Réponse

What is the type of SFF battery connector used for the LENOVO L12T1P33? I need to order them, but have had no success, even when supplying pix.

WmJ Robinson - Réponse

Ensure that the volume button and the piece of card that fits behind it are in a safe place, ready for re-assembly. Place them in position after re-securing the back plate above the battery and before closing the case.

Stuart Watson - Réponse

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 autre(s) ont terminé cette réparation.

Peter Newell

Membre depuis le 15/04/2014

568 Réputation

2 tutoriels rédigés

Équipe

Cal Poly, Team 7-21, Regan Spring 2014 Membre de l'équipe Cal Poly, Team 7-21, Regan Spring 2014

CPSU-REGAN-S14S7G21

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 9

7 derniers jours : 35

30 derniers jours : 167

Total : 19,778