Pièces

Aucune pièce nécessaire.

Flip the laptop over.
  • Flip the laptop over.

  • Place it on a flat, sturdy surface.

  • Remove the battery by moving the battery latch and slowly sliding the battery out.

  • Locate the drive enclosure.

Ajouter un commentaire

Use a small Phillips screwdriver to unscrew the single screw that holds down the drive enclosure cover.
  • Use a small Phillips screwdriver to unscrew the single screw that holds down the drive enclosure cover.

  • The screw is designed to remain within the plastic cover. (This is called a captive screw.) Don't worry about extracting it completely.

Ajouter un commentaire

  • Carefully remove the drive enclosure cover.

  • Do not break the small latches on the sides of the cover.

Ajouter un commentaire

  • Insert a spudger (or a similar tool) under the loop of the black pull tab, and gently pull it out from above the hard drive.

Ajouter un commentaire

  • Continue pulling on the pull tab until the hard drive and the two plastic rails come out of the enclosure.

  • Pull on the tab firmly but slowly. The hard drive should come out of the enclosure effortlessly.

Ajouter un commentaire

  • Remove the plastic rails from the old drive and place them on the new drive.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

23 autre(s) ont terminé cette réparation.

Michael Khmelnitsky

Membre depuis le 14/08/2013

681 Réputation

1 tutoriel rédigé

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 14

7 derniers jours : 97

30 derniers jours : 507

Total : 41,803