Aller au contenu principal

Introduction

Solid state drives are known to fail occasionally, but this doesn't mean you have to do away with your laptop entirely. Replacing a bad drive is as simple as removing the battery and a single screw. Failure can be caused by heat, voltage fluctuation, and age.

  1. Remove the ten 3.3 mm screws from the base cover using the T5 Torx screwdriver.
    • Remove the ten 3.3 mm screws from the base cover using the T5 Torx screwdriver.

  2. Slide opening tool between the base and back cover.
    • Slide opening tool between the base and back cover.

  3. Lift back cover.
    • Lift back cover.

  4. Remove the four 3.5 mm screws around the battery using the Phillips 00 screwdriver.
    • Remove the four 3.5 mm screws around the battery using the Phillips 00 screwdriver.

  5. Disconnect the battery from the motherboard.
    • Disconnect the battery from the motherboard.

  6. Gently lift and remove the battery.
    • Gently lift and remove the battery.

  7. Remove the one JIS 1 screw holding the solid state drive in place.
    • Remove the one JIS 1 screw holding the solid state drive in place.

  8. Gently pull the solid state drive out and up to remove it from the connector.
    • Gently pull the solid state drive out and up to remove it from the connector.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 autre(s) ont terminé cette réparation.

Andrew Keenan

Membre depuis le 30/11/2017

149 Réputation

1 tutoriel rédigé

Équipe

University of Maine, Team S1-G5, Diaz Fall 2017 Membre de l'équipe University of Maine, Team S1-G5, Diaz Fall 2017

UMAINE-DIAZ-F17S1G5

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 2

7 derniers jours : 34

30 derniers jours : 124

Total : 1,819