Pour réparer ensemble - Je crée un compte

Introduction

It is possible for your Lenovo Yoga 910-13IKB USB ports to degrade over time, resulting in low data transfer speeds or the inability to provide power through the port. If you notice these issues with the ports on your device, you may want to consider replacing them. Lenovo has made the fix quick, requiring only a JIS #00 screwdriver.

Ce dont vous avez besoin

Étape 1 Bottom Panel

Lenovo Yoga 910-13IKB USB Ports Replacement, Bottom Panel: étape 1, image 1 de 2

Lenovo Yoga 910-13IKB USB Ports Replacement, Bottom Panel: étape 1, image 2 de 2

Before you begin, be sure to turn off your laptop and unplug it from the outlet.
Turn the laptop over and remove the ten Torx T5 screws along the perimeter of the bottom panel.
Remove the panel.

Modifier

Étape 2

Use a Phillips screwdriver to remove the four M2 x 1.7 mm screws securing the battery to the laptop.
Remove the battery.

Modifier

Étape 3

Remove the six Phillips screws that attach the trackpad to the device.
Use a spudger to disconnect the ribbon cable connector from the trackpad.
Remove the trackpad using a spudger.

Modifier

Étape 4

Use a Phillips screwdriver to remove six screws attached to the USB ports on both sides of the device.
Detach both ribbon cables attached to each USB port with a spudger, then detach the USB ports.

Modifier

Étape 5

Use a small Phillips screwdriver to remove all single screw securing the SSD stick to the motherboard.
Slide the SSD stick from the port on the motherboard.

Modifier

Étape 6

Lenovo Yoga 910-13IKB USB Ports Replacement: étape 6, image 3 de 3

Use a small Phillips screwdriver to remove four screws from the fans.
Remove the back connector strip using a spudger to pry it off of the device.
Remove the fans.
Now, only the bottom panel should remain.

Modifier

Étape 7 Battery

Lenovo Yoga 910-13IKB USB Ports Replacement, Battery: étape 7, image 1 de 1

Remove the four 3 mm Phillips #0 screws holding the battery in place.

Modifier

Étape 8

Lenovo Yoga 910-13IKB USB Ports Replacement: étape 8, image 3 de 3

Disconnect the battery cable from its motherboard socket by gently pulling it towards the battery. The spudger tool may be needed to lift the flap seal.
Pull parallel to the battery, not straight up.
Pull evenly on the width of the cable so that no individual wire is overly strained.
Lift the battery out.