Aller au contenu principal

Les Paul Wireless Guitar Strummer Replacement

Ce dont vous avez besoin

  1. Les Paul Wireless Guitar Strummer Replacement, Les Paul Wireless Guitar Body Teardown: étape 1, image 1 de 1
    • Remove batteries

  2. Les Paul Wireless Guitar Strummer Replacement: étape 2, image 1 de 2 Les Paul Wireless Guitar Strummer Replacement: étape 2, image 2 de 2
    • Remove void warranty sticker

    • The sticker is covering a torx screw

  3. Les Paul Wireless Guitar Strummer Replacement: étape 3, image 1 de 3 Les Paul Wireless Guitar Strummer Replacement: étape 3, image 2 de 3 Les Paul Wireless Guitar Strummer Replacement: étape 3, image 3 de 3
    • Unscrew the 11 screws securing the back of the body using a T10 Torx screwdriver. Each screw is 1 cm long.

    • Push level, this will detach the back of the guitar from the front.

    • Carefully remove the back of the body

    • The battery pack cord is attached to both sides of the guitar, be careful not to tear it apart.

    • The neck connector may be stuck to the back so be sure to detach it before fully pulling

  4. Les Paul Wireless Guitar Strummer Replacement, Strummer: étape 4, image 1 de 2 Les Paul Wireless Guitar Strummer Replacement, Strummer: étape 4, image 2 de 2
    • Remove the 4 screws from the back of the strum chip using a Phillips PH1 screwdriver. each of these screws are 1.2 cm each.

    • Remove the 4 inner screws, each are 0.8 cm.

    • Make sure that when putting back together, the 4 inner screws line up with the small plastic piece underneath.

  5. Les Paul Wireless Guitar Strummer Replacement: étape 5, image 1 de 3 Les Paul Wireless Guitar Strummer Replacement: étape 5, image 2 de 3 Les Paul Wireless Guitar Strummer Replacement: étape 5, image 3 de 3
    • Remove the two plastic holders on the underside of the chip.

    • Pull out the the plastic piece on each side of the strummer.

    • Lift the strummer out of it's location

  6. Les Paul Wireless Guitar Strummer Replacement: étape 6, image 1 de 3 Les Paul Wireless Guitar Strummer Replacement: étape 6, image 2 de 3 Les Paul Wireless Guitar Strummer Replacement: étape 6, image 3 de 3
    • Take the top black cover off the strummer.

    • Slide the black rod out of the side.

    • Clean if needed.

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autres ont terminé cette réparation.

Chris

Membre depuis le 10/18/13

881 Réputation

6 tutoriels rédigés

4 commentaires

Hi recently bought this controller again and the up strum has stopped functioning. Hoping this will fix it. Thanks

liamiley91 - Réponse

Did this fix your issue? Thinking about trying it.

D. Preston Peek -

Same here, i want to it try but want to know if i will be able to do it altough i’m not really good with these kind of work

Sébastien Fortuny - Réponse

This guitar don't have star power with up guitar? Where is sensor?

Leandro Loureiro - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 3

7 derniers jours : 13

30 derniers jours : 102

Total : 19,366