Introduction
Guide for disassembly to allow for repair, greasing, and cleaning of parts of baitcaster.
Ce dont vous avez besoin
Document vedette
-
-
Refer to the featured document for specific part names and exploded view. Determine whether you have the right-handed or left-handed reel.
Demander à FixBot
-
-
-
Slide switch to 'open' on left side of reel to remove left cover.
-
-
-
Remove the palm-side cover, then spool assembly from center frame of reel.
-
-
-
Remove lube-port screw using small Phillips screwdriver.
-
-
-
-
Unscrew star-drag until it is loose, remove it and the handle washer from the shaft.
-
-
-
Remove three spool cover screws from reel.
-
-
-
Pry 2 drag spring washers, and 1 click holder washer off to finish removing side cover.
-
-
-
Remove the pinion yoke and 2 pinion yoke springs
-
-
-
Remove drive gear and accompanying drag and ratchet washers.
-
-
-
At this point, you have disassembled the reel enough to where you can clean parts, remove dust and debris , or replace individual parts
-
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
2 autres ont terminé cette réparation.
Pièces jointes
