Introduction

Has your disco ball stopped rotating and turned into a weird, multi-colored lamp? Use this guide to avoid the party-foul and get that ball spinning!

Pièces

  1. Turn the device over so that the base is on top.
    • Turn the device over so that the base is on top.

  2. Peel off the piece of metal that is glued to hold the two halves of the base together.
    • Peel off the piece of metal that is glued to hold the two halves of the base together.

    • You may need rubber cement to reapply the piece of metal when reassembling the device.

  3. %Livraison gratuite pour toute commande supérieure à 100,00 $US ou contenant un Pro Tech Toolkit !

    Parcourez notre boutique

    Vous avez déjà réparé quelque chose ? Vous êtes un génie.

    Partagez votre réparation avec le hashtag #ImAGenius

    Nous sommes tous des génies

    Partagez votre réparation avec le hashtag #ImAGenius

  4. Unscrew the four 10mm Phillips head screws on the bottom of the device. Once the base is removed, the device should look as shown on the picture.
    • Unscrew the four 10mm Phillips head screws on the bottom of the device.

    • Once the base is removed, the device should look as shown on the picture.

  5. Use a pair of tweezers to crush the sides of the wirenuts. The wirenuts are crimped to lock the wires in place. Usually the wires are just twisted into them.
    • Use a pair of tweezers to crush the sides of the wirenuts.

    • The wirenuts are crimped to lock the wires in place. Usually the wires are just twisted into them.

    • Pull all of the wires out of the wirenuts.

  6. Separate the wires that belong to the motor. The wires should be small and black.
    • Separate the wires that belong to the motor.

    • The wires should be small and black.

    • Remove the motor.

Conclusion

To reassemble your device, follow these instructions in reverse order, starting from step five.

Une autre personne a terminé cette réparation.

Courtney Elliott

Membre depuis le 14/01/2014

354 Réputation

3 tutoriels rédigés

Équipe

Cal Poly, Team 17-3, Forte Winter 2014 Membre de l'équipe Cal Poly, Team 17-3, Forte Winter 2014

CPSU-FORTE-W14S17G3

5 membres

7 tutoriels rédigés

Where can you find a replacement motor?

bellyjb - Réponse

I can't find one either!!!!

Dallin - Réponse

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 24

Total : 1,376