Logitech Extreme 3D Pro Disassembly of the base

Introduction

After extended use certain parts may require cleaning or replacement. This guide will assist you in safely disassembling the base portion of the joystick. This will require to have to handle already disassembled.

Ce dont vous avez besoin

Étape 1 Disassembly of the handle

Logitech Extreme 3D Pro Disassembly of the base, Disassembly of the handle: étape 1, image 1 de 1

Remove these three Phillips #1 screws:
Two 10mm screws.
One 7mm screw.

Traduire

Étape 2

Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.
Remove the two 10mm Phillips #1 screws.

Traduire

Étape 3

Pull apart the joystick chassis by hand.
Release this clip located underneath the hand rest
The circuit board will be loose and may fall down.

Traduire

Étape 4 Disassembly of the base

Logitech Extreme 3D Pro Disassembly of the base, Disassembly of the base: étape 4, image 1 de 1

Remove the eight 10mm Phillips #1 screws from the bottom.

Traduire

Étape 5

Logitech Extreme 3D Pro Disassembly of the base: étape 5, image 3 de 3

Flip the joystick upright.
Lift up the sliver base cover and feed the loose circuit board through.
Careful with the wires still attached to the silver base cover from the bottom of the joystick.