Réparez vos affaires Communauté Boutique

Logitech Extreme 3D Pro Top button circuit board Replacement

Introduction

The top buttons and the trigger are typically the most used, meaning the dip switches could become the first to be worn. This will require replacement for full use of the joystick.

Ce dont vous avez besoin

  1. Logitech Extreme 3D Pro Top button circuit board Replacement, Disassembly of the handle: étape 1, image 1 de 1

    • Remove these three Phillips #1 screws:

    • Two 10mm screws.

    • One 7mm screw.

    Modifier

  2. Logitech Extreme 3D Pro Top button circuit board Replacement: étape 2, image 1 de 1

    • Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.

    • Remove the two 10mm Phillips #1 screws.

    Modifier

  4. Logitech Extreme 3D Pro Top button circuit board Replacement: étape 3, image 1 de 2 Logitech Extreme 3D Pro Top button circuit board Replacement: étape 3, image 2 de 2

    • Pull apart the joystick chassis by hand.

    • Release this clip located underneath the hand rest

    • The circuit board will be loose and may fall down.

    Modifier

  5. Logitech Extreme 3D Pro Top button circuit board Replacement, Top button circuit board: étape 4, image 1 de 3 Logitech Extreme 3D Pro Top button circuit board Replacement, Top button circuit board: étape 4, image 2 de 3 Logitech Extreme 3D Pro Top button circuit board Replacement, Top button circuit board: étape 4, image 3 de 3

    • Remove the three 7mm Phillips #1 screws from the button board.

    • Remove the button board from the plastic top.

    • When taken apart the plastic buttons can fall out.

    Modifier

  6. Logitech Extreme 3D Pro Top button circuit board Replacement: étape 5, image 1 de 2 Logitech Extreme 3D Pro Top button circuit board Replacement: étape 5, image 2 de 2

    • Disconnect the cable from the button board.

    Modifier

  7. Logitech Extreme 3D Pro Top button circuit board Replacement: étape 6, image 1 de 2 Logitech Extreme 3D Pro Top button circuit board Replacement: étape 6, image 2 de 2

    • Disconnect the smaller cable from the button board.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autres ont terminé cette réparation.

Auteur

avec 1 autre contributeur

Emanuel Canela

Membre depuis le 01/25/18

1 297 Réputation

7 tutoriels rédigés

Badges: 14

+ 11 badges supplémentaires

Équipe

USF Tampa, Team S7-G1, Passmore Spring 2018 Membre de l'équipe USF Tampa, Team S7-G1, Passmore Spring 2018

USFT-PASSMORE-S18S7G1

4 membres

7 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 2

7 derniers jours : 4

30 derniers jours : 26

Total : 2,063