Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Avant de commencer, éteignez le clavier en mettant l'interrupteur en position OFF.
-
-
-
Retournez tout le clavier, les touches doivent être en dessous.
-
-
-
Insérez le bout plat d'une spatule dans l'espace entre le tiroir de la pile et la surface supérieure du clavier.
-
Faites pivoter la spatule vers le bas, vers le haut du clavier, pour faire levier sur le tiroir et le faire sortir de sa cavité.
-
-
-
Poussez le tiroir de la pile avec votre spatule jusqu'à ce qu'il sorte du clavier.
-
Retirez le tiroir de la pile.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Steps are described in this guide Remplacement de la pile du clavier Logitech K750. Turn off the keyboard before removing the battery.
-
Trash old ML2032 battery in special container!
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Be careful to not crack the plastic deck. Don't pull it off hard.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the seven black Phillips screws.
-
Remove the 22 silver screws.
-
Put the screws somewhere into the bowl to not lose them and try to remember the position of the black ones.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Unclip the back pannel from the front (keys) pannel.
-
When you flip the (keys) pannel you can notice that both solar panels have a pair of cables.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
I have decided to desolder the long cable (red and green one) because they are far away from the logic board so I will not transfer heat to it while desoldering them.
-
Tape desoldered cables so they do not come in contact with anything.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Insert fresh CL2032 battery in the battery compartment - check the polarity a close battery tray.
-
Annulation : je n'ai pas terminé ce tutoriel.
20 autres ont terminé cette réparation.
44 commentaires
How long did the CR2032 battery last in use?
I'm thinking not very long so I'm considering attaching a CR123 (big 3V photo lithium battery) holder to the underside and wiring it in.
Thanks for the guide!
Less difficult: I just covered the solar panels with thick 3M black tape. No charging according to the solar app and keyboard working fine with CR2032 (until replacement ML2032 comes in from China...)
Hey, thats a pretty good tip - I'll use that when battery in my mum's K750 keyboard goes away.
I would just ensure that Solar App is showing zero in under a direct light of your desk lamp.
Endrju -