Aller au contenu principal

Introduction

Is there a scratch, chip, or crack in your lens causing your image to be blurry? Replacing the lens may solve this problem.

  1. Remove the six 10mm Torx T10 screws on the camera face. Remove the six 10mm Torx T10 screws on the camera face.
    • Remove the six 10mm Torx T10 screws on the camera face.

  2. Remove the exterior lens cover.
    • Remove the exterior lens cover.

  3. Remove the foam ring around the lens with tweezers. Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step. Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.
    • Remove the foam ring around the lens with tweezers.

    • Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.

  4. Remove the two 5mm Phillips #1 screws.
    • Remove the two 5mm Phillips #1 screws.

    • Remove the two 8mm Phillips #0 screws.

    • When reassembling, tighten the top and bottom 5mm screws first, followed by the left and right 8mm screws.

  5. Remove the LED board with tweezers.
    • Remove the LED board with tweezers.

    • It is unnecessary to unplug the LED board from internal components for lens replacement.

  6. Use the Phillips #000 to remove the three 3mm screws on the face of the camera lens Use the Phillips #000 to remove the three 3mm screws on the face of the camera lens
    • Use the Phillips #000 to remove the three 3mm screws on the face of the camera lens

  7. Remove the camera lens.
    • Remove the camera lens.

    • After replacing camera lens and before reassembly it is encouraged to clean new lens surface with a microfiber lens cleaning cloth

Conclusion

To reassemble your device, follow these instructions in reverse order.

Alex Kusmierz

Membre depuis le 26/09/2016

601 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team 16-1, Eyestone Fall 2016 Membre de l'équipe USF Tampa, Team 16-1, Eyestone Fall 2016

USFT-EYESTONE-F16S16G1

4 membres

12 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 617