Aller au contenu principal

Introduction

Are your video recording's lacking audio or experiencing audio distortion? Try replacing the microphone to solve this problem.

  1. Remove the six 10mm Torx T10 screws on camera face. Remove the six 10mm Torx T10 screws on camera face.
    • Remove the six 10mm Torx T10 screws on camera face.

  2. Remove the exterior lens cover.
    • Remove the exterior lens cover.

  3. Remove the LED foam ring with tweezers. Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step. Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.
    • Remove the LED foam ring with tweezers.

    • Be aware, the electronic components of the LED board may be compromised if you use your fingers instead of tweezers for this step.

  4. Remove the two 5mm Phillips #1 screws.
    • Remove the two 5mm Phillips #1 screws.

    • Remove the two 8mm Phillips #0 screws.

    • When reassembling, tighten the left and right 8mm screws first. Followed by the top and bottom 5mm screws.

  5. Remove the two 5mm Phillips #1 screws.
    • Remove the two 5mm Phillips #1 screws.

  6. Use tweezers to disconnect the microphone wires from the internal components of camera. Use tweezers to disconnect the microphone wires from the internal components of camera. Use tweezers to disconnect the microphone wires from the internal components of camera.
    • Use tweezers to disconnect the microphone wires from the internal components of camera.

  7. Remove the 4mm Flathead #4 screw on the bottom of the camera. Remove the weatherproof gasket around the microphone with tweezers. Remove the weatherproof gasket around the microphone with tweezers.
    • Remove the 4mm Flathead #4 screw on the bottom of the camera.

    • Remove the weatherproof gasket around the microphone with tweezers.

  8. Remove the microphone. Push the microphone from the inside out for easier removal. Push the microphone from the inside out for easier removal.
    • Remove the microphone.

    • Push the microphone from the inside out for easier removal.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Alex Kusmierz

Membre depuis le 26/09/2016

601 Réputation

5 tutoriels rédigés

Équipe

USF Tampa, Team 16-1, Eyestone Fall 2016 Membre de l'équipe USF Tampa, Team 16-1, Eyestone Fall 2016

USFT-EYESTONE-F16S16G1

4 membres

12 tutoriels rédigés

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 144