Introduction

This guide explains how to re-attach the WiFi antenna.

Remove the 5.0mm screw using the Phillips #0 head screwdriver.
  • Remove the 5.0mm screw using the Phillips #0 head screwdriver.

Ajouter un commentaire

Insert metal spudger as shown in the picture. Move spudger along  to the other side until both snaps come loose.
  • Insert metal spudger as shown in the picture. Move spudger along to the other side until both snaps come loose.

Ajouter un commentaire

  • Picture shows the removed battery cover.

Ajouter un commentaire

  • Slide the battery out by pulling on one of two plastics tabs.

Ajouter un commentaire

  • Remove the remaining five 6.0 mm Phillips #0 screws.

Ajouter un commentaire

  • Use the spudger to remove the back cover. Insert the spudger between the back and front cover. Once inserted, you will need to move it around the perimeter to release the snaps holding it together.

Ajouter un commentaire

  • Once back cover is removed, the speaker wire will need to be removed. Use tweezers to remove wire.

Ajouter un commentaire

  • Begin by heating the exposed end of the grey lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.

  • For more information on soldering, check out this repair guide: iFixit Soldering

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Yancey Crase

Membre depuis le 26/03/2018

217 Réputation

2 tutoriels rédigés

Équipe

IUPUI, Team S1-G4, Harley Spring 2018 Membre de l'équipe IUPUI, Team S1-G4, Harley Spring 2018

IUPUI-HARLEY-S18S1G4

7 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 3

Total : 48