Pièces

Aucune pièce nécessaire.

Start with the bottom of the laptop facing up.
  • Start with the bottom of the laptop facing up.

Ajouter un commentaire

Remove the 15 screws from the bottom of the laptop with a PH1 screwdriver.
  • Remove the 15 screws from the bottom of the laptop with a PH1 screwdriver.

  • Remove the bottom plate

  • Keep track of all the screws and which slot they came from, as they slightly differ. We recommend this system: lay out on a piece of paper and pretending the paper is the device. Place the screws on the paper approximately where they would go

Ajouter un commentaire

  • Remove the screw holding down the battery with a PH1 screwdriver.

  • Pull out the battery.

Ajouter un commentaire

  • Open the laptop up as if you were going to use it.

  • Wedge a spudger in between the screen bezel and work it around to separate it.

Ajouter un commentaire

  • Remove the screws holding in the screen at the corners with a PH1 screwdriver.

  • Be very careful as the screen may tilt forward so make sure your hand is right is on the screen when the screw comes off.

Ajouter un commentaire

  • Remove the bezel from the screen.

  • Remove the two screws located at the bottom of the screen using the PH1 screwdriver.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Samer Soukieh

Membre depuis le 19/02/2018

209 Réputation

1 tutoriel rédigé

Équipe

USF Tampa, Team S15-G5, Boczar Spring 2018 Membre de l'équipe USF Tampa, Team S15-G5, Boczar Spring 2018

USFT-BOCZAR-S18S15G5

4 membres

5 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 3

30 derniers jours : 32

Total : 103