Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Éteignez votre Mac mini, déconnectez tous les câbles et retournez-le.
-
Insérez la spatule Jimmy dans la jointure entre l'aluminium du couvercle supérieur e de la partie inférieure en plastique.
-
La spatule doit s'enfoncer d'environ 9 mm.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Keep working around the perimeter, freeing the clips along the final edge.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Slightly squeeze the two retaining arms toward each other and lift the AirPort antenna off its post.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the single Phillips screw securing the Bluetooth board to the internal frame.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the Bluetooth board off the internal frame and use the flat end of a spudger to pry the Bluetooth antenna cable connector up off the Bluetooth board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Pull the Bluetooth antenna cable out from underneath all the cables connected to the interconnect board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the Bluetooth antenna by pushing up on both sides of the board as close to the center post as possible.
-
Remove the Bluetooth antenna from the internal frame.
-
Annulation : je n'ai pas terminé ce tutoriel.
5 autres ont terminé cette réparation.