Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Éteignez votre Mac mini, déconnectez tous les câbles et retournez-le.
-
Insérez la spatule Jimmy dans la jointure entre l'aluminium du couvercle supérieur e de la partie inférieure en plastique.
-
La spatule doit s'enfoncer d'environ 9 mm.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Keep working around the perimeter, freeing the clips along the final edge.
-
-
-
-
Nous allons d'abord retirer l'antenne AirPort, située dans le coin inférieur gauche de cette image.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to pry the audio ribbon cable connector up off the interconnect board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to pry the following connectors up off the interconnect board:
-
Fan cable.
-
Speaker cable.
-
IR board cable.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to pry the hard drive thermal sensor cable connector up off the interconnect board.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two Phillips screws securing the interconnect board to the optical drive.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use the flat end of a spudger to separate the interconnect board from the optical and hard drives.
-
Pull the interconnect board away from the drives and remove it from the internal frame.
-
Annulation : je n'ai pas terminé ce tutoriel.
5 autres ont terminé cette réparation.