Introduction
Use this guide to replace a dead hard drive.
Ce dont vous avez besoin
Vidéo d'introduction
-
-
Remove the following ten screws:
-
Three 14.4 mm Phillips #00 screws
-
Three 3.5 mm Phillips #00 screws
-
Four 3.5 mm shouldered Phillips #00 screws
-
-
-
Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board.
-
-
-
-
Remove the two Phillips screws securing the hard drive bracket to the upper case.
-
-
-
Remove the four 6.0 mm T6 Torx hard drive retaining posts from the sides of the hard drive.
-
Transfer the hard drive retaining posts to your new hard drive.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
271 autres ont terminé cette réparation.
12 commentaires
Is there any specific order that's best for putting back the screws?
Start with the corners but after that it dose not matter