Aller au contenu principal

Réparez vos affaires

Droit à la réparation

Pièces & Outils

Introduction

This guide has been updated by iFixit staff! Read the new, official guide here.

  1. Remove the following 10 screws securing the lower case to the MacBook Pro 13" Unibody:
    • Remove the following 10 screws securing the lower case to the MacBook Pro 13" Unibody:

    • Red Seven 3 mm Phillips screws.

    • Orange Three 13.5 mm Phillips screws.

  2. Slightly lift the lower case and push it toward the rear of the computer to free the mounting tabs.
    • Slightly lift the lower case and push it toward the rear of the computer to free the mounting tabs.

  3. Remove the following tri-wing screws securing the battery to the upper case:
    • Remove the following tri-wing screws securing the battery to the upper case:

    • Red One 5.5 mm tri-wing screw

    • Orange One 13.5 mm tri-wing screw.

  4. Manta Precision Bit Set

    112 embouts pour toute réparation.

    Upgrade Your Toolbox

    Manta Precision Bit Set

    Upgrade Your Toolbox
  5. Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.
    • Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.

  6. Lift the battery out of the upper case
    • Lift the battery out of the upper case

  7. Remove the ribbon cable by releasing it from the ZIF connector on the underside of the trackpad and also from the socket that attaches it to the logic board. Remove the ribbon cable by releasing it from the ZIF connector on the underside of the trackpad and also from the socket that attaches it to the logic board.
    • Remove the ribbon cable by releasing it from the ZIF connector on the underside of the trackpad and also from the socket that attaches it to the logic board.

  8. Remove the four 1.2mm #00 Phillips head screws from rear of the trackpad. Remove the four 1.2mm #00 Phillips head screws from rear of the trackpad.
    • Remove the four 1.2mm #00 Phillips head screws from rear of the trackpad.

Conclusion

To reassemble your device, follow these instructions in reverse order.

8 autre(s) ont terminé cette réparation.

SIMRAN

Membre depuis le 30/10/2010

6 309 Réputation

1 tutoriel rédigé

Équipe

Master Techs Membre de l'équipe Master Techs

Community

293 membres

929 tutoriels rédigés

I had better luck using the #000 Phillips to get the 1.2mm screws out during step 7.

benchampa - Réponse

I accidentally disabled my track pad in the system preferences how do I enable it again when the trackpad wont click?

Nicholas Noriega - Réponse

Ajouter un commentaire

Afficher les statistiques:

Dernières 24 heures : 2

7 derniers jours : 2

30 derniers jours : 3

Total : 19,675