Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two pieces of kapton tape covering the display data cable.
-
Remove the strip of tape securing the iSight cable to the LCD.
-
Peel the three antenna straps off the lower edge of the LCD.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the display data cable by pulling its connector toward the bottom edge of the display, away from the socket on the LCD.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two Phillips screws securing the ground straps for the display data cable and LED driver board cable to the clutch cover.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the Phillips screw hidden behind the display data cable.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the three Phillips screws behind antenna straps along the bottom edge of the display.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
To remove the clutch assembly, first insert the flat end of a spudger into the gap between the clutch hinge and the clutch cover where the cables exit.
-
While prying the clutch assembly away from the clutch hinge with your spudger, use a plastic opening tool to increase the gap between the clutch cover and the front display bezel.
-
Work your way along the length of the clutch cover to fully separate the adhesive.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Push the clutch assembly off each of the clutch hinges and remove it from the display.
-
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.