Cette version peut contenir des modifications incorrectes. Passez au dernier aperçu vérifié.
Ce dont vous avez besoin
-
-
Avec vos doigts, écartez les deux clips de verrouillage de la batterie puis retirez la batterie de l'ordinateur.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the three identical Phillips screws from the memory door.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the memory door up enough to get a grip on it, and slide it toward you, pulling it away from the casing.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the two Phillips screws in the battery compartment near the latch.
-
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the following 6 screws:
-
Two 10 mm T6 Torx screws on either side of the RAM slot.
-
Four 14.5 mm Phillips screws along the hinge.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Remove the four Phillips screws on the port side of the computer.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Rotate the computer 90 degrees and remove the two Phillips screws from the rear of the computer.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Rotate the computer 90 degrees again and remove the four Phillips screws from the side of the computer.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift up at the rear of the case and work your fingers along the sides, freeing the case as you go. Once you have freed the sides, you may need to rock the case up and down to free the front of the upper case. This stage can be quite tricky. Over the DVD reader are 4 tabs set back which pull out vertically.
-
Note that the two small tongues on the left hand front of the upper case may bend while you remove the upper case. When re-installing, you may need to bend them back to fit in the grooves in the lower case.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Disconnect the trackpad and keyboard ribbon cable from the logic board, removing tape as necessary.
-
Remove the upper case.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Lift the Bluetooth board out of its slot next to the hard drive and use a spudger to disconnect the Bluetooth antenna cable.
-
-
Cette étape n’est pas traduite. Aidez à la traduire
-
Use a spudger to pry the Bluetooth antenna up from its housing in front of the hard drive.
-
Lift the Bluetooth antenna out of the computer.
-
Annulation : je n'ai pas terminé ce tutoriel.
6 autres ont terminé cette réparation.