Réparez vos affaires Communauté Boutique

MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement

Conditions préalables uniquement
Ce tutoriel est uniquement destiné à être utilisé comme prérequis d'autres tutoriels. Il ne se suffit pas à lui-même.

Introduction

This guide is an internal guide that is used only as a prereq.

Ce dont vous avez besoin

  1. MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement, (Anti-Glare Option) Bluetooth Board: étape 1, image 1 de 2 MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement, (Anti-Glare Option) Bluetooth Board: étape 1, image 2 de 2

    • Disconnect the Bluetooth cable by pulling the male end straight away from its socket.

    • Pull the connector parallel to the face of the logic board, not straight up.

    • Use the flat end of a spudger to pry the Bluetooth antenna cable from its socket on the board.

    Traduire

  3. MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement: étape 2, image 1 de 2 MacBook Pro 15" Unibody 2.53 GHz Mid 2009 (Anti-Glare Option) Bluetooth Board Replacement: étape 2, image 2 de 2

    • Remove the two 8 mm Phillips screws securing the Bluetooth/camera cable retainer to the upper case.

    • One of the screws may remain captive in the Bluetooth/camera cable ground loop. If replacing the display, be sure to transfer this screw to the new unit.

    • Lift the Bluetooth board/cable retainer assembly out of the upper case.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 1,861