Aller au contenu principal

MacBook Pro 15" Unibody Early 2011 Lower Case Replacement

Ce dont vous avez besoin

  1. MacBook Pro 15" Unibody Early 2011 Lower Case Replacement, Lower Case: étape 1, image 1 de 1
    • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm (14.1 mm) Phillips screws.

    • Seven 3 mm Phillips screws.

    • When removing these screws, note how they come out at a slight angle. They must be reinstalled the same way.

  2. MacBook Pro 15" Unibody Early 2011 Lower Case Replacement: étape 2, image 1 de 1
    • Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case.

    • Remove the lower case and set it aside.

Conclusion

To reassemble your device, follow these instructions in reverse order.

36 autres ont terminé cette réparation.

2 commentaires

For re-assembly, tilt the screw driver slightly at an angle tangent to the case's edge when screwing in the seven 3 mm Phillips screws. Screw the 13 mm screws directly downward. This should ensure better thread engagement.

Matthew Adler - Réponse

Another method for insuring screws end up on the right thread is to turn the screw in reverse (anti-clockwise) to begin with until you feel a click, then you'll know the screw has fallen into the thread correctly and you can drive it home clockwise.

John Ward - Réponse

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 6

30 derniers jours : 27

Total : 28,788