Introduction
Accessing the RAM in this computer is straightforward and requires minimal disassembly.
Ce dont vous avez besoin
-
-
Remove the following ten screws securing the lower case to the upper case:
-
Three 13.5 mm (14.1 mm) Phillips screws.
-
Seven 3 mm Phillips screws.
-
-
-
-
Use the edge of a spudger to pry the battery connector upwards from its socket on the logic board.
-
-
-
Release the tabs on each side of the RAM chip by simultaneously pushing each tab away from the RAM module.
-
After the RAM chip has popped up, pull it straight out of its socket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
115 autres ont terminé cette réparation.
3 commentaires
There's a visual of the screw configuration on the apple support website:
Great tutorial, but I think moderate might be a bit of an understatement; this project took me roughly five minutes, and I’ve never taken apart a computer before.