Aller au contenu principal

Introduction

Remove the lower case to access most components in your MacBook Pro 17" Unibody.

  1. Remove the following ten screws securing the lower case to the upper case:
    • Remove the following ten screws securing the lower case to the upper case:

    • Three 13.5 mm Phillips screws.

    • Seven 3 mm Phillips screws.

  2. Wedge your fingers between the lower case and the vent, and lift upward to release the two clips holding the lower case to the upper case. During reassembly, carefully align the lower case and then press it firmly until both clips engage.
    • Wedge your fingers between the lower case and the vent, and lift upward to release the two clips holding the lower case to the upper case.

    • During reassembly, carefully align the lower case and then press it firmly until both clips engage.

    • Remove the lower case.

Conclusion

To reassemble your device, follow these instructions in reverse order.

15 autre(s) ont terminé cette réparation.

Is there a DIY on replacing the rubber feet?

retrotechpost - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 12

30 derniers jours : 39

Total : 15,749