Réparez vos affaires Communauté Boutique

MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement

Introduction

Faulty Wi-Fi or Bluetooth connection? Replace the AirPort/Bluetooth cable.

Ce dont vous avez besoin

  1. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement, Lower Case: étape 1, image 1 de 1

    • Remove the eight 4 mm Phillips screws securing the lower case to the MacBook.

    Modifier

  2. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement: étape 2, image 1 de 3 MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement: étape 2, image 2 de 3 MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement: étape 2, image 3 de 3

    • The lower case is constructed of rubber-coated aluminum. Do not excessively bend the aluminum during removal, as any permanent deformation will cause tolerance issues after reassembly.

    • Slightly lift the lower case near the vent opening.

    • Continue running your fingers between the lower and upper cases until the upper case pops off its retaining clips.

    • The location of these three clips is shown in the third picture.

    Modifier

  4. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement, Battery: étape 3, image 1 de 1

    • For precautionary purposes, we advise that you disconnect the battery connector from the logic board to avoid any electrical discharge. This step is optional and is not required.

    • Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.

    • It may be easier to use your fingernails to lift up on both sides of the connector.

    Modifier

  5. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement, AirPort/Bluetooth Cable: étape 4, image 1 de 2 MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement, AirPort/Bluetooth Cable: étape 4, image 2 de 2

    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.

    • Carefully peel the AirPort/Bluetooth ribbon cable from its channel within the rear speaker assembly.

    Modifier

  6. MacBook Unibody Model A1342 AirPort/Bluetooth Cable Replacement: étape 5, image 1 de 1

    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the right speaker.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

10 autres ont terminé cette réparation.

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 6

30 derniers jours : 16

Total : 14,499