Ce tutoriel a des changements plus récents. Passer à la dernière version non vérifiée.
Introduction
This guide will show you how to replace the hard drive cable.
Ce dont vous avez besoin
-
-
Remove the eight 4 mm Phillips screws securing the lower case to the MacBook.
-
-
-
Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.
-
-
-
-
Remove two 11 mm Phillips screws securing the hard drive bracket to the upper case.
-
-
-
Remove the 3.1 mm Phillips screw securing the hard drive cable to the upper case.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
19 autres ont terminé cette réparation.