Aller au contenu principal

Ce tutoriel a des changements plus récents. Passer à la dernière version non vérifiée.

MacBook Unibody Model A1342 Rear Speaker Assembly Replacement

Conditions préalables uniquement
Ce tutoriel est uniquement destiné à être utilisé comme prérequis d'autres tutoriels. Il ne se suffit pas à lui-même.

Ce dont vous avez besoin

  1. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement, Rear Speaker Assembly: étape 1, image 1 de 1
    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.

  2. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 2, image 1 de 1
    • Remove the following screws securing the right speaker assembly to the upper case:

    • One 12 mm Phillips screw.

    • One 3 mm Phillips screw.

  3. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 3, image 1 de 1
    • Remove the single 2.2 mm Phillips screw inserted horizontally into the side of the optical drive.

  4. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 4, image 1 de 2 MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 4, image 2 de 2
    • Pry the AirPort and Bluetooth antenna connectors (3 total) up off the AirPort/Bluetooth card.

    • De-route the long antenna from its channel in the rear speaker housing.

  5. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 5, image 1 de 1
    • Use the flat end of a spudger to pry the rear speaker cable connector up off the logic board.

  6. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 6, image 1 de 1
    • Remove the rear speaker assembly from the upper case.

  7. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 7, image 1 de 2 MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 7, image 2 de 2
    • Carefully peel the AirPort/Bluetooth cable from its channel within the rear speaker assembly.

    • Use the flat end of a spudger to pry the AirPort/Bluetooth cable up off the rear speaker.

  8. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 8, image 1 de 1
    • Remove three 3 mm Phillips screws securing the AirPort/Bluetooth board to the rear speaker assembly.

  9. MacBook Unibody Model A1342 Rear Speaker Assembly Replacement: étape 9, image 1 de 1
    • Lift the AirPort/Bluetooth board up off the rear speaker assembly.

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 695