Introduction

The Macintosh IIsi Uses a 50-Pin SCSI Drive, that doesn't need to be terminated while in single configuration.

Pièces

Aucune pièce nécessaire.

Start by turning the computer around, and remove this #0 Phillips Screw.
  • Start by turning the computer around, and remove this #0 Phillips Screw.

  • There may or may not be a Phillips #0 screw here, depending on whether or not the computer has ever been serviced.

Ajouter un commentaire

Now lift these two clips, and slowly pivot the case up.
  • Now lift these two clips, and slowly pivot the case up.

  • You can now seperate the top of the computer from the rest of the machine.

Ajouter un commentaire

  • The Macintosh IIsi's hard drive is located ajacent to the ram and floppy drive.

  • Start by pushing these two tabs out, and lifting the drive up.

  • Then, flip the drive over, and remove the connection cables.

Ajouter un commentaire

  • The hard drive: A Quantum ProDrive LPS, made in 1990, and surprisingly, it still works!

  • This drive has an 80MB capacity, not very large by today's standards, but not bad way back then...

  • Believe it or not, hard drive construction hasn't changed much in the last 20 years. Other than a few new interfaces, the form factor, 3.5" width and 4-Pin 12V/5V power connector has stayed the same.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 autre(s) ont terminé cette réparation.

Chris Green

Membre depuis le 11/10/2009

32 161 Réputation

47 tutoriels rédigés

Équipe

Master Techs Membre de l'équipe Master Techs

Community

277 membres

730 tutoriels rédigés

Hello cano you please tell me how is the jumpering setting for a Quantum Prodrive LT 700MB

Juan - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 13

Total : 3,260