Réparez vos affaires Communauté Boutique

Mad Catz Street Fighter IV FightPad Circuit Board Replacement

Introduction

Use this as a guide to remove the motherboard so you can access the FightPad's buttons and directional pad.

Ce dont vous avez besoin

  1. Mad Catz Street Fighter IV FightPad Circuit Board Replacement, Rear and Side Case: étape 1, image 1 de 1

    • Use tweezers to completely remove the sticker from the rear of controller.

    Modifier

  2. Mad Catz Street Fighter IV FightPad Circuit Board Replacement: étape 2, image 1 de 1

    • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

    Modifier

  3. Mad Catz Street Fighter IV FightPad Circuit Board Replacement: étape 3, image 1 de 2 Mad Catz Street Fighter IV FightPad Circuit Board Replacement: étape 3, image 2 de 2

    • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

    • Use the plastic opening tool to pry the two cases apart.

    Modifier

  5. Mad Catz Street Fighter IV FightPad Circuit Board Replacement: étape 4, image 1 de 2 Mad Catz Street Fighter IV FightPad Circuit Board Replacement: étape 4, image 2 de 2

    • Remove the two rubber side grips.

    Modifier

  6. Mad Catz Street Fighter IV FightPad Circuit Board Replacement, RS-DP-LS Switch: étape 5, image 1 de 2 Mad Catz Street Fighter IV FightPad Circuit Board Replacement, RS-DP-LS Switch: étape 5, image 2 de 2

    • Locate RS-DP-LS switch.

    • Pull upwards on the switch to remove it.

    Modifier

  7. Mad Catz Street Fighter IV FightPad Circuit Board Replacement, Circuit Board: étape 6, image 1 de 1

    • Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

    Modifier

  8. Mad Catz Street Fighter IV FightPad Circuit Board Replacement: étape 7, image 1 de 3 Mad Catz Street Fighter IV FightPad Circuit Board Replacement: étape 7, image 2 de 3 Mad Catz Street Fighter IV FightPad Circuit Board Replacement: étape 7, image 3 de 3

    • Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.

    • Be careful with the wires connected to the circuit board itself as they are thin and delicate.

    • When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

    Modifier
Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Auteur

avec 8 autres contributeurs

Jefferson Hsu

Membre depuis le 09/18/12

411 Réputation

3 tutoriels rédigés

Badges: 9

+ 6 badges supplémentaires

Équipe

Cal Poly, Team 1-7, Propen Fall 2012 Membre de l'équipe Cal Poly, Team 1-7, Propen Fall 2012

CPSU-PROPEN-F12S1G7

4 membres

14 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 0

Total : 2,043