Introduction
A guide to accessing the GPS sensor.
Ce dont vous avez besoin
-
-
Remove the four rubber caps from the back by using the Phillips #00 screwdriver.
-
-
-
-
Remove the two screws on that are located on opposite sides of the board.
-
-
-
Carefully flip the circuit board out so you can get to the sensor easily.
-
Remove the tape holding the sensor to the display and take out the sensor.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulation : je n'ai pas terminé ce tutoriel.
Une autre personne a terminé cette réparation.