Réparez vos affaires Communauté Boutique

Magellan RoadMate 5120-LMTX Battery Replacement

Introduction

Rechargeable batteries eventually degrade and lose their ability to hold a charge. Once this happens, the only fix is to replace the battery. Ensure that your device is powered off before beginning this step.

Ce dont vous avez besoin

  1. Magellan RoadMate 5120-LMTX Battery Replacement, Back Cover: étape 1, image 1 de 3 Magellan RoadMate 5120-LMTX Battery Replacement, Back Cover: étape 1, image 2 de 3 Magellan RoadMate 5120-LMTX Battery Replacement, Back Cover: étape 1, image 3 de 3

    • Power off the Magellan RoadMate before beginning.

    • Remove the six 5mm Phillips #00 screws from the back of device.

    Traduire

  2. Magellan RoadMate 5120-LMTX Battery Replacement: étape 2, image 1 de 3 Magellan RoadMate 5120-LMTX Battery Replacement: étape 2, image 2 de 3 Magellan RoadMate 5120-LMTX Battery Replacement: étape 2, image 3 de 3

    • Pry back cover off with a plastic opening tool just enough to see where the speaker is attached to the motherboard.

    • Do not fully open the back cover or you risk damaging the speaker wire.

    • Use a spudger to disconnect the speaker connection from the motherboard.

    Traduire

  4. Magellan RoadMate 5120-LMTX Battery Replacement, Battery: étape 3, image 1 de 2 Magellan RoadMate 5120-LMTX Battery Replacement, Battery: étape 3, image 2 de 2

    • Run the tip of a spudger between the battery and the housing to loosen the double-sided tape holding the battery in.

    • Still using the spudger tool, pry the battery from the housing.

    • If you damage the tape while trying to remove the battery, you can replace it with any double-sided tape.

    Traduire

  5. Magellan RoadMate 5120-LMTX Battery Replacement: étape 4, image 1 de 3 Magellan RoadMate 5120-LMTX Battery Replacement: étape 4, image 2 de 3 Magellan RoadMate 5120-LMTX Battery Replacement: étape 4, image 3 de 3

    • Pull the edge of the tape up to remove the tape that holds the battery wire to the motherboard.

    • There is a clear rectangular adhesive strip that also needs to be removed with the pointy end of a spudger.

    • Slowly pull the connection from the motherboard.

    • Do not pull too hard or you will risk damaging the wires.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 3 autres contributeurs

Steven Prout

Membre depuis le 10/08/16

231 Réputation

2 tutoriels rédigés

Badges: 5

+ 2 badges supplémentaires

Équipe

IUPUI, Team 4-4, Wilson Fall 2016 Membre de l'équipe IUPUI, Team 4-4, Wilson Fall 2016

IUPUI-WILSON-F16S4G4

4 membres

6 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 4

Total : 472