Aller au contenu principal

Pièces

Aucune pièce spécifiée.

  1. First be sure to turn the power switch to the off position.
    • First be sure to turn the power switch to the off position.

    • Do this by turning the leftmost knob counter-clockwise as until the line points to "off."

  2. Now remove the battery. On the back of the device locate the battery cover. Remove it by pushing down on the clip.
    • Now remove the battery.

    • On the back of the device locate the battery cover.

    • Remove it by pushing down on the clip.

    • Then pull the piece of fabric until the battery comes out.

  3. Use the long, skinny phillips head screwdriver to remove the 4 7/16" screws on the back of the device in the four corners. Once unscrewed, do not try to take each screw out. Move to next step once all screwed have been unscrewed.
    • Use the long, skinny phillips head screwdriver to remove the 4 7/16" screws on the back of the device in the four corners.

    • Once unscrewed, do not try to take each screw out. Move to next step once all screwed have been unscrewed.

  4. Now pull the back panel off and place it down as shown. Pull the panel straight up so you do not lose the screws.
    • Now pull the back panel off and place it down as shown. Pull the panel straight up so you do not lose the screws.

  5. Use a soldering iron to disconnect the two wires from the speaker.
  6. Remove the two 7/16" screws located in the bottom left and top right corners with a phillips head screw driver. After removing the screws, the metal clips will need to be removed as well. Remove the two 7/16" screws located in the bottom left and top right corners with a phillips head screw driver. After removing the screws, the metal clips will need to be removed as well.
    • Remove the two 7/16" screws located in the bottom left and top right corners with a phillips head screw driver. After removing the screws, the metal clips will need to be removed as well.

  7. You may now remove the speaker by pulling it straight out.
    • You may now remove the speaker by pulling it straight out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

MacKinley

Membre depuis le 22/10/2013

675 Réputation

5 tutoriels rédigés

Équipe

University of Maryland, Team 1-1, Shastany Fall 2013 Membre de l'équipe University of Maryland, Team 1-1, Shastany Fall 2013

UMD-SHASTANY-F13S1G1

3 membres

5 tutoriels rédigés

So where do we find a replacement speaker? If no parts are required what is the point in taking the speaker out?

Patrick Gillett - Réponse

This speaker unavailable in Marlins. Any online sources. How should an untutored amateur repairer describe the replacement in order to get the right thing

Patrick Gillett - Réponse

Any speaker that will fit should work. Might want to check to make sure the Watts they consume are the same. I imagine that if you put a speaker in that consumes more Watts you could potentially over heat the power supply or other components.

MacKinley - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 7

30 derniers jours : 31

Total : 2,655