Outils

The access panel for all of these lights is on the inside of the trunk. There's one on each side. This guide will cover one side; simply repeat on the other to complete the job.
  • The access panel for all of these lights is on the inside of the trunk. There's one on each side. This guide will cover one side; simply repeat on the other to complete the job.

Ajouter un commentaire

The panel is secured with two thumb screws. Remove these.
  • The panel is secured with two thumb screws. Remove these.

Ajouter un commentaire

  • Pull the panel out and away from the back of the car, being careful not to force the bulbs out of the holes.

Ajouter un commentaire

  • There are five bulbs in each tail light housing. They are as follows:

    • Brake light

    • Reverse light

    • Tail light

    • Turn signal

    • Side marker

Ajouter un commentaire

  • To remove any of the bulbs simply turn them counter clockwise approximately a half turn and then pull them out of their socket.

Ajouter un commentaire

  • Three of the bulbs are #1156

  • One is a #96

  • One is a small 4W blub

Ajouter un commentaire

  • Before installing the new bulb consider cleaning the socket with a soft metal wire brush such as the brass brush shown to help remove any corrosion.

  • Then install the new bulb, reassemble the device, and finally, be sure to test that all of your rear lights are working before going for a drive.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 autre(s) ont terminé cette réparation.

Nicolas Siemsen

Membre depuis le 06/12/2013

28 805 Réputation

79 tutoriels rédigés

Équipe

Master Techs Membre de l'équipe Master Techs

Community

277 membres

747 tutoriels rédigés

Very informative, descriptive and point on analysis.

George T Peeke - Réponse

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 3

7 derniers jours : 22

30 derniers jours : 88

Total : 5,753