Introduction

This repair guide will show you how to replace the gaskets in the MerchSource the Black Series Boat Racers toy boat. The gaskets are foam pieces that secure the battery compartment in the boat from water leakage.

  1. Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver.
    • Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver.

    • Screw length is 16 mm.

  2. Remove the top of the boat by sliding it backwards and then pulling it off.
    • Remove the top of the boat by sliding it backwards and then pulling it off.

    • Grab the rubber gasket with tweezers and pull it out of the slot.

    • Gently remove the gasket and replace with a new one.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Monica Reece

Membre depuis le 31/08/2018

651 Réputation

5 tutoriels rédigés

Équipe

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 0

30 derniers jours : 23

Total : 50