Réparez vos affaires Communauté Boutique

Minolta QTsi Maxxum View Finder Replacement

Introduction

Replace your viewfinder if it breaks so that you can see through the camera to take pictures.

Ce dont vous avez besoin

  1. Minolta QTsi Maxxum View Finder Replacement, View Finder: étape 1, image 1 de 1

    • Locate the battery compartment on the bottom panel of camera.

    • Use a small coin to untwist and open the batter compartment door.

    • Twist the coin counterclockwise to unlock the battery compartment door.

    Traduire

  2. Minolta QTsi Maxxum View Finder Replacement: étape 2, image 1 de 1

    • Two batteries are located inside the battery compartment

    • Be careful, the batteries inside the compartment are small and easy to lose.

    • Remove the two batteries from inside the battery compartment by individually pulling each out.

    Traduire

  3. Minolta QTsi Maxxum View Finder Replacement: étape 3, image 1 de 1

    • When the batteries are removed from the compartment, one screw will be visible in the bottom of the chamber.

    • Unscrew the (1) black Phillips #00 5mm screw from the bottom of the battery chamber.

    • Be careful when unscrewing the screw because it's small and is easy to lose.

    Traduire

  5. Minolta QTsi Maxxum View Finder Replacement: étape 4, image 1 de 1

    • Remove the (2) black Phillips #00 5mm screws that lie on either side of the view finder.

    • Be careful because the two screws are small and are easy to lose.

    Traduire

  6. Minolta QTsi Maxxum View Finder Replacement: étape 5, image 1 de 1

    • Remove the (1) black Phillips #00 5mm screw from underneath the flash hood.

    • Be careful because the screw is small and is easy to lose.

    Traduire

  7. Minolta QTsi Maxxum View Finder Replacement: étape 6, image 1 de 2 Minolta QTsi Maxxum View Finder Replacement: étape 6, image 2 de 2

    • Once all screws are removed, the top of the camera should come off easily.

    • Be careful when removing the top, there are wires connected that could be damaged.

    Traduire

  8. Minolta QTsi Maxxum View Finder Replacement: étape 7, image 1 de 1

    • The viewfinder will fall when the screws are removed.

    • Remove the (2) black Phillips #00 5mm screws that hold the viewfinder.

    • Be careful because the screws are small and easy to lose.

    Traduire
Conclusion

To reassemble your device, follow these instructions in reverse order.

Auteur

avec 4 autres contributeurs

Maya Van Londen

Membre depuis le 10/10/16

315 Réputation

2 tutoriels rédigés

Badges: 12

+ 9 badges supplémentaires

Équipe

Sam Houston State, Team 12-4, Blackburne Fall 2016 Membre de l'équipe Sam Houston State, Team 12-4, Blackburne Fall 2016

SHSU-BLACKBURNE-F16S12G4

4 membres

5 tutoriels rédigés

0 commentaires

Ajouter un commentaire

Nombre de vues :

Dernières 24 heures : 1

7 derniers jours : 6

30 derniers jours : 20

Total : 823