Introduction

Use this guide to install a new power supply.

  1. Remove the following 8 Phillips #1 screws:
    • Remove the following 8 Phillips #1 screws:

      • One 22 mm Phillips #1 in the bottom right corner of the back panel.

      • One 18 mm Phillips #1 in the top middle of the back panel.

      • Six 18 mm Phillips #1 in the rest of the back panel.

    Ajouter un commentaire

  2. Pull the back panel off of the television by gripping the sides and rotating it down.
    • Pull the back panel off of the television by gripping the sides and rotating it down.

    Ajouter un commentaire

    • Remove the four 10 mm black Phillips #1 screws with fine thread that attach the protective case to the TV.

    Ajouter un commentaire

  3. Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK au moment de payer
    Livraison gratuite pour les commandes de plus de 20 $
    Indiquez le code BLUEANDBLACK
    • Disconnect the lamp ballast power connection and the light engine power connection by pressing down the tab and pulling out the connection.

    Ajouter un commentaire

    • Pull out the protective case holding the power supply and input/output boards.

    Ajouter un commentaire

    • Unplug the power connections on the power supply board by pressing down the tabs on the connections and gently pulling the connections away from the board.

    Ajouter un commentaire

    • Remove the five 10 mm silver, coarse threaded Phillips #0 screws securing the power supply board to the case.

    Ajouter un commentaire

    • Unlatch white clips from the power supply board by pushing in the tabs and lifting up on the motherboard.

    • This may require excessive force and patience. Using an interchangeable screwdriver with no bit may help. Place it over the white plastic notches and pull in the direction of the tab release while pulling upward on the power supply board to release.

    Ajouter un commentaire

    • Remove the power supply board from its protective case by pulling it straight up and away from the case.

    Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Une autre personne a terminé cette réparation.

Graham Copland

Membre depuis le 03/10/2012

43 Réputation

1 tutoriel rédigé

Équipe

Cal Poly, Team 18-39, Regan Fall 2012 Membre de l'équipe Cal Poly, Team 18-39, Regan Fall 2012

CPSU-REGAN-F12S18G39

4 membres

6 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 0

7 derniers jours : 1

30 derniers jours : 9

Total : 2,927