Introduction

Use this guide to replace the pull-out antenna through the back of the device.

Pièces

Aucune pièce nécessaire.

Remove the battery by sliding it down the rails to which it is connected.
  • Remove the battery by sliding it down the rails to which it is connected.

Ajouter un commentaire

Locate a Flat-head or a Phillips head screwdriver.
  • Locate a Flat-head or a Phillips head screwdriver.

  • Insert the screwdriver into the holes that connect the key pad guard to the rear casing in the plastic rod.

  • The following step may require a substantial amount of force.

  • Use the screwdriver to push the rods towards each other until they click out of their locked positions.

Ajouter un commentaire

  • Slide off the antenna guard and locate the four clips on the exterior of the rear casing.

  • Simultaneously push the clips outward while lifting the rear casing and keyguard away from the front casing.

Ajouter un commentaire

  • Locate and unplug the black component of the current antenna from the motherboard.

  • Under the black component should be a blue component. Unscrew this component in order to free the antenna.

Ajouter un commentaire

  • Slide the antenna out of the green tubing.

  • Slide the green tubing out of its hole.

Ajouter un commentaire

  • Insert the new green tubing into the corresponding slot.

Ajouter un commentaire

  • Insert the new antenna into the green tubing.

Ajouter un commentaire

  • Screw the blue piece of the antenna into the threaded hole on the motherboard until it is tight.

Ajouter un commentaire

  • Align the protruding wire on the black component with the corresponding hole on the motherboard.

  • Push the wire into the hole.

Ajouter un commentaire

  • Reverse the instructions from Step 2 to re-install the keypad guard and rear casing onto the device.

Ajouter un commentaire

  • Push down on the antenna guard until it clicks into place.

Ajouter un commentaire

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew Lam

Membre depuis le 17/04/2012

28 Réputation

5 tutoriels rédigés

Équipe

Cal Poly, Team 9-46, Regan Spring 2012 Membre de l'équipe Cal Poly, Team 9-46, Regan Spring 2012

CPSU-REGAN-S12S9G46

5 membres

8 tutoriels rédigés

Ajouter un commentaire

Voir les statistiques:

Dernières 24 heures : 1

7 derniers jours : 2

30 derniers jours : 4

Total : 1,446